Filter
Top Products
SECTION 6—SEAT AND BACK
9000 Topaz™Wheelchair 34 Part No. 1100869
Replacing Back Upholstery
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove the eighteen (18) mounting screws and washers that secure the existing back
upholstery to the back canes.
2. Install and securely tighten the new back upholstery to the back canes with the
eighteen (18) mounting screws and washers starting with the top hole of the back cane.
FIGURE 6.2 Replacing Back Upholstery
Adjusting Back Height
NOTE: For this procedure, refer to FIGURE 6.3.
1. Remove the four (4) mounting screws and locknuts that secure the two (2) back canes
to the wheelchair frame.
2. Remove the bottom two (2) back upholstery mounting screws from the cane.
3. Reposition the back canes to one (1) of three (3) height adjustment positions:
NOTE: Holes numbered from bottom to top for reference only. (There are no numbers on the back
canes.)
NOTE: The mounting screws must be securely tightened into the threaded mounting holes of the
wheelchair frame before installing the locknuts.
4. Reinstall the four (4) mounting screws through the threaded mounting holes of the
wheelchair frame and the back cane. Securely tighten.
5. Reinstall the four (4) locknuts. Securely tighten
HOLE NUMBER 1 & 2 2 & 3 3 & 4
BACK HEIGHT
16 in. 17 in. 18 in.
Back Cane
Mounting
Screws
Washers
Back Upholstery