Filter
Top Products
SECTION 4—FRONT RIGGINGS
9000 Topaz™Wheelchair 26 Part No. 1100869
Swingaway Footrest Height Adjustment
NOTE: For this procedure, refer to FIGURE 4.2.
1. Remove the swingaway footrest
assembly. Refer to Installing/Removing
Swingaway Footrest Assembly on
page 25.
NOTE: Lay the assembly on a flat surface to
simplify this procedure.
2. Remove the two (2) bolts and locknuts
that secure the lower footrest assembly
to the upper footrest support.
3. Reposition the lower footrest assembly
to the desired height.
4. Install and securely tighten the two (2)
bolts and locknuts.
5. Repeat STEPS 1-4 for the other footrest.
FIGURE 4.2 Swingaway Footrest Height
Adjustment
6. Reinstall the swingaway footrest assembly. Refer to Installing/Removing Swingaway
Footrest Assembly on page 25.
Installing/Removing Elevating Legrest Assembly
NOTE: For this procedure, refer to FIGURE 4.3.
Installing
1. Place elevating legrest assembly on the outside of the wheelchair and install the hinge
plates onto the hinge pins on the wheelchair frame.
2. Rotate elevating legrest assembly toward the inside of the wheelchair until it locks in
place.
3. Repeat STEPS 1 and 2 for the other legrest assembly.
NOTE: The footplates will be facing each other when locked in place.
4. While sitting in the wheelchair, adjust the legrest to the correct height. Refer to
Adjusting Elevating Legrest Assembly
on page 27.
Lower
Footrest
Assembly
Bolts and
Locknuts
Upper
Footrest
Support