Filter
Top Products
11 WHEELS
Part No 1171880 69 Invacare
®
Top End Reveal
™
Wheelchair
4. Tighten the locking screw.
5. Reinstall the rear wheel and quad-release axle onto the wheelchair. Refer to Removing/Installing Rear Wheels
on page 66.
6. Flip the handle of the quad-release axle down to release the detent pin ensuring that the locking pins are fully released.
7. Repeat the above procedures until the quad-release axle locks correctly.
FIGURE4 Adjusting Quad-Release Handles
Removing Play from Rear Wheels
1. With the rear wheel and quad-release axle still mounted onto the wheelchair, make the following adjustment:
• Tighten the length adjusting screw until there is no in and out movement of the quad-release axle and rear wheel.
Adjusting Locknut
(On Quick-Release Axle)
Length
Adjustment
Screw
Removing Play from Rear Wheels
Adjusting Quad-Release Handle In and/or Out
Locking Pins
Camber Bar
Locking
Screw
Quad Release
Handle