Filter
Top Products
6 FOOTREST
Invacare
®
Top End Reveal
™
Wheelchair 34 Part No 1171880
2. Slide the existing footrest tubes out of the wheelchair frame and install new footrest by reversing this step.
3. Position the new footrest to a determined height.
4. Tighten the mounting screws and locknuts to secure the footrest to the wheelchair frame.
5. Adjust the footplate to the desired position. Refer to Adjusting Footplate Angle
on page 34 and/or Adjusting Footplate Depth on page 34.
Adjusting Footplate Angle
1. Loosen, but DO NOT remove the two clamp screws and locknuts (not shown) that secure the footplate to the two footrest tubes and clamp.
2. Position the footplate to the necessary angle to accommodate the user and center clamp on the two footrest tubes.
3. Retighten the two mounting screws and locknuts.
Adjusting Footplate Depth
1. Remove the two clamp screws and locknuts (not shown) that secure footplate to the footrest tubes and clamp.
2. Move the footplate to one of two mounting positions to accommodate the user.
3. Using the two clamp screws and locknuts, secure the footplate to the footrest tubes and clamp.
Be sure plastic bushings are in place before installing mounting screws.
Observe the angle of footplate for reinstallation. Be sure footplate and clamp are centered in the width of the chair.