Filter
Top Products
11 WHEELS
Invacare
®
Top End Reveal
™
Wheelchair 68 Part No 1171880
11.3 Replacing Quad-Release Axles
1. Remove rear wheel and the existing quick-release axle from the
wheelchair. Refer to Removing/Installing Rear Wheels
on page 66.
2. Remove existing quick-release axle from rear wheel.
3. Insert new quad-release axle through rear wheel hub.
4. Slide locking collar onto quad-release axle until it is snug against
rear wheel and tighten securely with allen screw.
5. Reinstall rear wheel and the quad-release axle onto the wheelchair.
Refer to Removing/Installing Rear Wheels
on page 66.
6. Flip the handle of the quad-release axle down to release the detent
pin ensuring that the locking pins are fully released.
7. If detent pin does not fully release, proceed to Adjusting
Quad-Release Handles on page 68.
8. Repeat STEPS 1-7 for the opposite rear wheel.
FIGURE3 Replacing Quad-Release Axles
11.4 Adjusting Quad-Release Handles
In and/or Out
1. Remove rear wheel and the quad-release axle from the wheelchair. Refer to Removing/Installing Rear Wheels on page 66.
2. Loosen the locking screw.
3. Make one or both of the following adjustments:
• If the quad-release handle is not releasing the locking pins completely, rotate the quad-release handle approximately one-quarter turn
clockwise.
• If the quad-release handle hits the spokes of the rear wheel when assembled, rotate the quad-release handle approximately one-quarter turn
counterclockwise.
Quick-Release
Axle
Rear Wheel Hub
Locking Collar
Allen Screw
End of Quick Release axle is shown for reference
only. It is not visible when inserted into camber bar.
For this procedure, refer to FIGURE4 on page 69.