Filter
Top Products
9 SEAT
Invacare
®
Top End Reveal
™
Wheelchair 60 Part No 1171880
9 Seat
9.1 Replacing Seat Upholstery
1. Remove the seat cushion from the wheelchair.
2. Remove mounting screws that secure the seat upholstery to the
seat frame.
3. Lift up on the back upholstery cover separating the fastening strips
of the back upholstery cover from the fastening strips of the seat.
4. Remove the existing seat upholstery.
5. Secure new seat upholstery with mounting screws. Tighten
securely.
6. Install the seat cushion onto the wheelchair.
• For 12 to 13 depth, use 8 mounting screws
• For 14 depth, use 10 mounting screws
• For 15 to 16 depth, use 12 mounting screws
• For 17 to 19 depth, use 14 mountings screws
• For 19 to 20 depth, use 16 mounting screws
FIGURE1 Replacing Seat Upholstery
ƽ
WARNING
ALWAYS perform these procedures in the presence of an assistant. The position of the footrest, camber tube, seat angle,
back angle, the tautness of the back upholstery as well as the user's condition are directly related to the wheelchairs
stability. Any change to one or any combination of the five may cause the wheelchair to decrease in stability. Use EXTREME
caution when using a new seating position. The addition of anti-tippers may be required.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely -
otherwise injury or damage may occur.
Fastening Strips located in
between the back
upholstery cover and the
seat upholstery
Seat Upholstery