Filter
Top Products
11 WHEELS
Invacare
®
Top End Reveal
™
Wheelchair 66 Part No 1171880
11 Wheels
11.1 Removing/Installing Rear Wheels
1. Perform one of the following:
• Quick-Release - Push in the tip of the quick-release axle and pull axle and wheel away from the wheelchair.
• Quad-Release - Lift up on the handle of the quad-release axle and pull axle and wheel away from the wheelchair.
2. Repeat STEP 1 for the opposite rear wheel.
3. Reinstall the rear wheels onto the wheelchair by reversing STEPS 1-2.
4. If there is too much movement of the rear wheel assembly in an “in and out” motion, refer to Adjusting Quick-Release Axles
on page 67 or
Adjusting Quad-Release Handles
on page 68.
ƽ
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
ƽ
CAUTION
Changing the size of the rear wheels can affect the performance of the wheelchair. Contact Invacare at the telephone
numbers on the back of this manual before changing rear wheel size.
For this procedure, refer to FIGURE1 on page 67.
ƽ
WARNING
Pull on the rear wheel to make sure the detent pin and locking pins of the quick/ quad-release axle are fully released before
operating wheelchair.
Keep locking pins clean.