Filter
Top Products
MODEL DO-03/04 SECTION 5.0
SOFTWARE CONFIGURATION
Program
Calibrate (see previous page)
Diagnostic Variable (see previous page)
Main
Menu
Alarms 1, 2, and 3 setpoints
4 mA or 0 mA
20 mA
Present output current
Alarm Setpoints
Output setpoints
Test output 1 or 2
Test alarm 1, 2, 3, or 4
Simulated tests
Configure
Display
Main
Sensor
Oxygen
Outputs
Output 1 and 2
control
Measurement: main snr, temp.
Output 1 and 2
setup
Range (0-20 or 4-20 mA)
Dampen
Hold - keep last value
Hold - go to specified value
Fault
Hold feature setup
Alarms
Alarm 1, 2, & 3
control
Measurement: main snr, pH, temp.
Alarm 1, 2, & 3
setup
Alarm: High, low, or off
Setpoint
Hysteresis
Delay
Relay default
Interval timer
Timer: Alarm 1, 2, or 3 or disable
Interval
Repeats
On time
Off time
Recovery time
Alarm 4 setup
Feed limit timer
Feed limit: Alarm 1, 2, or 3 or disable
Timeout
Continued on following page
FIGURE 5-1. Menu Tree for the 54eA Analyzer
(continued)
Sensor type and manufac.
Units: ppm, ppb, % sat
°C or °F
Output 1 (mA or %FS)
Output 2 (mA or %FS)
Language
Line 3 display
Display contrast
Timeout (on or off)
Timeout - limit
Polling address
19