Filter
Top Products
12 Meter specifications
Section 1: Introduction Daniel 3410 Series Ultrasonic Gas Flow Meter Installation Manual
June 2014 3-9000-759 Rev D
1.6 Meter specifications
Consult your Daniel Sales and Service representative to ensure you purchase the correct
components and seals for your application.
CONTENTS MAY BE UNDER PRESSURE
When the meter is under pressure, DO NOT attempt to remove or adjust the transducer holder.
Attempting to do so may release pressurized gases, resulting in serious injury or equipment damage
CONTENTS MAY BE HAZARDOUS
The meter must be fully depressurized and drained before attempting to remove the transducer holder.
If gas or fluid begins to leak from the transducer holder, stop immediately and reinstall the holder.
Failure to do so may cause serious injury or equipment damage.
A. Transducer holder
A.
ESCAPING GASES OR LIQUIDS HAZARD
The purchaser of the meter is responsible for the selection of Daniel components/seals and materials
compatible with the chemical properties of gas flow measurement.
Failure to select suitable meter components/seals may cause escaping gases or liquids, resulting in injury or
equipment damage.