Filter
Top Products
Daniel 3410 Series Ultrasonic Gas Flow Meter Installation Manual Section 4: Configuration
3-9000-759 Rev D June 2014
Using a Field Communicator to configure the meter 97
5. Wire Analog Input 1 (AI1) and Analog Output 1 (AO1) as shown in Figure 4-20 and
Appendix A, drawing DMC-005324.
Figure 4-20 Field Communicator wiring diagram for the 3410 Series electronics
6. Use the leads provided with the Field Communicator to connect to your device.
7. Press and hold the
Power button on the Field Communicator until the green light blinks.
8. Use the touch screen on the Field Communicator, the keypad or use the stylus to
navigate through the device menus.
9. Refer to the Menu tree in Section D.1.1 of the Daniel HART Field Device Specification
manual (P/N 3-9000-762) for the device fast key sequences. Included in the menu tree
are:
• Diagram Page 1 - 3410 Series Root Menu; Overview, Configure>Manual Setup
• Diagram Page 2 - Configure|Manual Setup (continued) and Alerts Setup
• Diagram Page 3 - Service Tools|Alerts and Variables
• Diagram Page 4 - Service Tools|Variables (continued), Service Tools|Trends, and
Service Tools|Maintenance
10. If you encounter problems, refer to the contact information on the back cover of this
manual or the contacts included in the Field Communicator User’s Manual.