Filter
Top Products
40 Appendix A
Password={password, $SN, $MAC,
$IP, $UN, $PW, $TN}
Specifies the password to log in to the application
server. Either a conventional log-in password or a
variable can be used.
Variable and Description
password — Conventional log-in password
$SN — Serial number
$MAC — MAC address
$IP — IP Address
$UN — Sign-on name
$PW — Sign-on password
$TN — Terminal name
CAUTION: The application server password is not
encrypted; not specifying it is strongly recommended.
The user will be prompted to enter the password
when the connection is made. This application server
password directive never starts a line, so it can be
distinguished from the thin client user sign-on
password (which starts a line).
ping={yes, no} Yes/no option to enable ping. For non-published
application connections, a ping (ICMP) is sent to the
host server prior to connecting to verify that the host
is reachable.
Protocol={4, 5} Access servers running RDP 4 or RDP 5. To access
servers running RDP 4, set the protocol to 4.
Default=5 (servers running RDP 5 are accessed).
RDDomainName=<domain> For RDP only.
Specifies the
domain of the RD Gateway. It
applies only if SameLoginForRD is not defined or
set to no.
RDPassword=<password> For RDP only.
Specifies the
password of the RD Gateway. It
applies only if SameLoginForRD is not defined or
set to no.
RDServer=<IPaddress> For RDP only.
Specifies the RD Gateway server, it should be used in
combination with UseRDGateway=yes
RDUserName=<name> For RDP only.
Specifies the
username of the RD Gateway. It
applies only if SameLoginForRD is not defined or
set to no.
Reconnect={yes, no} Yes/no option to automatically reconnect to an
application server after a disconnection.
Option Value and Action
Yes — (default) - Immediately restarts the connection
30 seconds after a disconnect. The default for a
reconnection is 30 seconds.
No — Does not reconnect after a disconnect.
ReconnectSeconds={1-3600} Specifies the interval to wait (in seconds, an integer
between 1 and 3600) before automatically restarting
the connection after a disconnection. Valid range is 1
to 3600.
Table 12 RDP Connect Options, Continued
Option Description