Filter
Top Products
ADSP-21369 EZ-KIT Lite Evaluation System Manual 1-5
Using EZ-KIT Lite
To start up an EZ-KIT Lite session in VisualDSP++:
1. Verify that the yellow USB monitor LED (LED11, located near the
USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run VisualDSP++.
2. From the Start menu, navigate to the VisualDSP++ environment
via the Programs menu.
If you are running VisualDSP++ for the first time, the New Session
Figure 1-1. EZ-KIT Lite Hardware Setup