Interface Configuration Commands
See also “Remote Interface Configuration” in chapter 4 starting on page 150.
SYSTem:INTerface {GPIB|RS232}
Select the remote interface. Only one interface can be enabled at a time.
The
GPIB interface is selected when the instrument is shipped from
the factory.
SYSTem:LOCal
Place the instrument in the local mode for
RS-232 operation. All keys on
the front panel are fully functional while in the local mode.
SYSTem:REMote
Place the instrument in the remote mode for
RS-232 operation. All keys
on the front panel, except , are disabled while in the remote mode.
SYSTem:RWLock
Place the instrument in the remote mode for
RS-232 operation.
This command is the same as the SYSTem:REMote command except
that all keys on the front panel are disabled, including the key.
<Ctrl-C>
Clear the operation in progress over the
RS-232 interface and
discard any pending output data. This is equivalent to the IEEE-488
Device Clear action over the GPIB interface.
5
Chapter 5 Remote Interface Reference
Interface Configuration Commands
269
