Filter
Top Products
SECTION 12—OPTIONS
Part No 1100868 63 9000 Jymni™Pediatric Series
Installing the 1-inch Forward Rear Wheel Positioner
ƽ WARNING
DO NOT use the 1-inch forward bracket on recliner wheelchairs OR adjustable
angle back wheelchair. Otherwise injury or damage may occur.
Recliners and Wheelchairs with 1-Inch Forward Rear Wheel Positioner Only:
Anti-tippers MUST BE attached at all times.
NOTE: For this procedure, refer to FIGURE 12.2.
1. Remove both rear wheels from the wheelchair. Refer to Removing/Installing the Rear
Wheels on page 45.
2. Position the right hand 1-inch forward rear wheel positioner onto the right hand side
of the wheelchair frame (FIGURE 2).
NOTE: Right and left hand sides of the wheelchair are determined from the users position.
3. Secure the 1-inch forward rear wheel positioner to the wheelchair frame using the two
mounting screws, spacers and locknuts.
4. Repeat STEPS 2-3 to Install the left hand 1-inch forward wheel positioner.
5. Reinstall the rear wheels onto the 1-inch forward brackets. Refer to
Removing/Installing the Rear Wheels on page 45.
6. If necessary, install the anti-tippers. Refer to Installing/Adjusting the Anti-Tippers on
page 51.
FIGURE 12.2 Installing the 1-inch Forward Rear Wheel Positioner
Spacer
Mounting Screw
Spacer
1-Inch Forward Rear
Wheel Positioner
Mounting Screw
Locknuts