Filter
Top Products
SECTION 4—FRONT RIGGINGS
9000 Jymni™Pediatric Series 34 Part No 1100868
Installing/Removing Elevating Legrest Assembly
NOTE: For this procedure, refer to FIGURE 4.4.
Installing
1. Place elevating legrest assembly on the outside of the wheelchair and install the hinge
plates onto the hinge pins on the wheelchair frame.
2. Rotate elevating legrest assembly toward the inside of the wheelchair until it locks in
place.
3. Repeat this procedure for other legrest assembly.
NOTE: The footplates will be facing each other when locked in place.
4. After seated in wheelchair, adjust the legrest to correct height.Refer to Adjusting the
Elevating Legrest Assembly on page 35.
Removing
1. To release the elevating legrest assembly push the legrest release handle toward the
inside of the wheelchair (facing the front of the wheelchair) and swing the legrest
assembly to the outside of the wheelchair.
2. Lift the elevating legrest assembly off of the hinge pins.
FIGURE 4.4 Installing/Removing Elevating Legrest Assembly
Step 1
Steps 2 and 3
Bolt and
Locknut
Calfpad Assembly
Lower Footrest
Assembly
Footplate
Hinge Pins
Elevating Legrest
Assembly
Legrest Release
Handle
Hinge Plates
Legrest J934A-14 shown.
Legrest J934A installs the
same.