Filter
Top Products
SECTION 6—SEAT AND BACK
Part No 1100868 43 9000 Jymni™Pediatric Series
3. Pull the loose back cane out of the existing back upholstery.
4. Pull the existing back upholstery up and over the mounted back cane.
5. Install the new back upholstery over the mounted back cane.
6. Slide the loose back cane through the new back upholstery.
7. Secure the back cane to the wheelchair frame with the two allen screws and locknuts.
8. Secure the new back upholstery to the back canes with the existing mounting screws
and washers.
FIGURE 6.2 Replacing Back Upholstery
Adjusting the Back Height
ƽ WARNING
The seat depth, back height/angle, seat angle, size/position of the front casters,
size/position of the rear wheels, anti-tipper model, as well as the user condition
directly relate to the stability of the wheelchair. Any change to one (1) or any com-
bination of the ten (10) may cause the wheelchair to decrease in stability. These
adjustments MUST be performed by a qualified technician.
NOTE: For this procedure, refer to FIGURE 6.3.
NOTE: Back canes must be adjusted to the same height.
1. Remove the two mounting screws and locknuts that secure the two back canes to the
wheelchair frame.
Back Upholstery
Washer
Mounting
Screws
Back Cane
DETAIL “A”
DETAIL “B”
Back Cane
Mounting
Screws
Locknuts
Wheelchair
Frame