Filter
Top Products
3-53
Cisco Transport Manager Release 6.0 User Guide
78-16845-01
Chapter 3 Building the Network
3.8.4 Resetting the Resync Interval
Note This command is unavailable unless at least one NE in the selection is in the In Service or Under
Maintenance state.
Step 2 To rediscover all ONS 155xx, CRS-1, or XR 12000 NEs in the network, choose Configuration >
ONS 155XX, Cisco CRS-1, or Cisco XR 12000 > Rediscover All.
Note This command is unavailable unless at least one NE in the network is in the In Service or Under
Maintenance state.
Step 3 Click Yes in the confirmation dialog box to initiate rediscovery.
For CRS-1 and XR 12000 NEs, if the Rediscover or Rediscover All operation succeeds, the Audit Log
records the following message:
Rediscover of the NE:
<NE_IP_address>
successfully completed.
Rediscover All of the NEs:
<list_of_NE_IP_addresses>
successfully completed.
Rediscover and Rediscover All operations are available only for in-service or under-maintenance NEs.
If you try to initiate rediscovery for NE(s) that are not in service or under maintenance, the Error Log
records the following minor error:
Skipping rediscover for:
<NE_IP_address>
as its state is neither In Service nor Under
Maintenance.
Note If a Rediscover process is already in progress on a single NE and you choose Rediscover again, the
request will be accepted but not executed by CTM. Similarly, if a Rediscover All process is already in
progress and you choose Rediscover All again, the request will be accepted but not executed by CTM.
3.8.4 Resetting the Resync Interval
The Resync Interval setting displays the frequency at which the configuration is rediscovered, retrieved,
and processed for the NEs. The following information is retrieved:
• General system information including node name, system time zone, SNTP configuration, and
power monitoring information
• NE’s network information including IP address, static routes, OSPF, and RIP configuration
• Card provisioning data
• DCC configuration
• Timing synchronization
• Protection group configured on the NE
• Ethernet Spanning Tree configuration
• Alarm profiles
• Security configurations
• NE defaults