Filter
Top Products
3-17
Cisco Transport Manager Release 6.0 User Guide
78-16845-01
Chapter 3 Building the Network
3.5.2 Adding NEs
Step 1 Open a terminal window and SSH or Telnet to the switch.
Step 2 Enter the cnfpasswd command to change the service-level password for all nodes. The following
example is shown:
xxyyzz.7.PXM.a >
xxyyzz.7.PXM.a > cnfpasswd
Enter existing password:
Enter new password:
Re-enter new password:
Local password for user cisco changed.
Step 3 When you are prompted for a password, you must:
a. Enter the existing password.
b. Enter the new password.
c. Re-enter the new password for confirmation.
3.5.2 Adding NEs
From the Domain Explorer or Subnetwork Explorer tree, you can use the Add New NE wizard to add a
single NE or multiple NEs.
3.5.2.1 Adding a Single NE
Note If you are adding an ONS 155xx NE, first verify that the NE is covered by an entry in the SNMP
Community String table.
Note Table 3-7 describes the fields in the Add New NE wizard.
Step 1 Select a node in the Domain Explorer or Subnetwork Explorer tree; then, choose File > Add Network
Element(s) (or click the Add Network Element(s) tool). The Add New NE wizard opens.
Note You cannot add a new NE to the Discovered Network Elements or Deleted Network Elements
group.
Step 2 Enter the following information:
a. NE model
b. NE type
c. NE addition—Click the Single NE Addition radio button
d. IP address
Step 3 Click Next.