Installation
19
RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules
Installing RDM Modules Into an RDA Enclosure
Installing any of the RDM modules is an easy task. The individual modules are shipped with the four mounting
screws enclosed.
FIG. 23 illustrates the inside of an RDA-ENC6 enclosure and the mounting slots.
The modules are positioned in the appropriate slot and secured using the supplied screws.
The RDA-ENC2 enclosure contains a ground-terminating lug. The RDA-ENC4, RDA-ENC6, RDA-ENC6B,
and RDA-ENC12B enclosures contain a neutral terminating block and a ground-terminating lug.
While it is possible to wire the enclosure with 3-phase Y, please remember a single
RE-DM4 or RE-DM6 will only support one Y-phase.
To prevent possible personal injury or death, disconnect power to the enclosure at
the breaker box before attempting to install any AMX Lighting modules.
FIG. 23 Enclosure module mounting slots and mounting screw holes
Neutral terminal block
Ground terminal block
Module mounting slots
Mounting screw
holes for modules
(4 per slot)
The RE-DM4 and RE-DM6 take up 2 Radia enclosure slots each, so an RDA-ENC6
can hold only three RE-DM4/RE-DM6 devices.