The user parameter switches are outlined below. (*: Factory setting)
Switch 00 - Home position settings
Digit Purpose
0 Stamp 0: Off* 1: On
1
2
Contrast home position
Digit 2 Digit 1 Setting
0 0 Normal *
0 1 Lighten
1 0 Darken
3 Do not use this setting.
4
5
Resolution Digit 5 Digit 4 Setting Digit 5 Digit 4 Setting
0 0 Standard* 1 0 Fine
0 1 Detail 1 1 Do not use this.
6
Transmission mode 0: Memory Transmission*
1: Immediate Transmission
7 Halftone 0: Off* 1: On
Switch 01
Digit Purpose
0 to 6 Do not change these settings.
7
If you change any of the contrast, resolution, transmission mode, or halftone settings
before making a transmission, then:
0: The setting(s) will not return to the home position after the transmission.
1: The setting(s) will return to the home position after the transmission.*
Switch 02 - Printing of various items on received messages
Digit Purpose
0
Mark to be printed at the receiving side to distinguish messages that are sent from
your machine when it is acting as a forwarding station (Feature Expander required).
0: Off 1: On *
1
Center mark 0: Off* 1: On
The center mark is not printed when the machine is used for making copies.
2 Reception time 0: Off* 1: On
3 TSI printing 0: Off* 1: On
4 Checkered mark 0: Off* 1: On
5 to 7 Do not change these settings.
Forwarding Mark
ON/OFF SWITCHES AND USER PARAMETERS TECHNICAL REFERENCE
170
