Switching Reports On/Off
Some of these reports can be switched on or off.
To switch a report on or off, do the following (see page 168 if you need more
information about the User Parameter settings adjustment procedure).
1. Function 6 2 2 2 2 6 3 and Yes.
2. Yes.
The settings for switch 0 are now shown
on the bottom line of the display.
3. Press until the settings for switch 03 are
shown.
Each digit from 0 to 7 controls one of the
reports (except digit 1) as follows.
Digit 7 6 5 4 3 2 10
Digit Purpose
0
Transmission result report 0: Off 1: On Default Setting: On
(Memory Transmission)
1 Do not change this setting.
2 File reserve report 0: Off 1: On Default Setting: Off
3 Polling reserve report 0: Off 1: On Default Setting: Off
4 Polling result report (polling reception) 0: Off 1: On Default Setting: On
5
Transmission result report 0: Off 1: On Default Setting: On
(Immediate Transmission)
6 Polling clear report 0: Off 1: On Default Setting: On
7 TCR 0: Off 1: On Default Setting: On
4. If you wish to change a setting, press the appropriate key on the keypad. For
example, to change digit 2, press 2 on the ten keypad.
5. Finish: Yes and Function.
NOTE: ❐ To switch the Confidential File Report on or off, use Function 63 (see
page 73).
❐ To switch the Error Report on or off, contact a service technician.
REPORTS
REPORTS AUTOMATICALLY PRINTED REPORTS
125
