7. Input the time: 0 9 0 0 from the ten key
pad.
To change AM to PM and the other
way around, press # . And press Yes.
∗
8. Repeat from the step 5 for the second
timer. Press to move the cursor under
the time.
∗
And input the time 0 6 0 0, for example,
from the ten key pad for the timer value .
To change AM to PM and the other
way around, press # . And press Yes.
∗
KEEPING THE HEATER ON ALL DAY: Set both timers to ON = 12:00AM.
KEEPING THE HEATER OFF ALL DAY: Set both timers to OFF = 12:00AM.
9. Either:
Program the timer for another day: Go back to step 3.
Finish: Yes and Function.
NOTE: To print the received messages while the heater is off, press any key. After all the
messages have been printed, the heater will stay on for 5 minutes before switching off again.
Because of this, the Night timer does not give you complete security for received documents.
For this type of security, use the Memory Lock feature; see page 125.
Temporarily Switching the Heating roller
During the Night Timer cycle that the heating roller is off, it may be switched back
on:
When you hold the Energy Saver key for a few seconds.
When you insert a document in the feeder.
When you pick up the handset, or press On Hook Dial key.
After you leave the machine alone for a while, the heating elements will turn back
off. Note that if the automatic saver mode is disabled by a service technician, the
night timer will not turn back on.
ADVANCED
FEATURES
ADVANCED FEATURES OTHER
165
