IN1606 Scaling Presentation Switcher • Operation 12
Menu Overview
In the OSD menu, the IP address and firmware version are displayed in the top border. The
active input settings and output resolution are displayed in the bottom border. The OSD
menu contains nine submenus with various submenu items of adjustable settings or device
information. Use the Menu, Enter, and Navigation buttons to navigate the OSD menu.
To open the OSD menu:
1. Connect a display device to an HDMI output connector.
2. Press the Menu or Enter button to open the OSD menu.
To navigate the OSD menu:
1. Press the Up or Down button to navigate the nine submenus. The following table shows
the nine submenus and their respective submenu items.
Submenus
Quick
Setup
User
Presets
Picture
Controls
Input Output Audio Advanced Communication
Device Info
(Read Only)
Submenu Items
Auto-Image Recall Image
Position
Auto-Image Resolution Audio Mute Test Pattern Remote Port Unit Name
Input
Format
Save Image Size Input Format HDMI “A”
Format
Audio Format Screen Saver/
Timeout
MAC Address Firmware
EDID Clear Brightness/
Contrast
Film Mode HDMI “B”
Format
Gain Auto-Image DHCP Temperature
Output
Resolution
Color/Tint Horizontal/
Vertical Start
HDCP
Notification
Mic/Line 1
Gain/Phantom
Aspect Ratio IP Address Active Input
Details
Audio Mute Detail Horizontal/
Vertical Active
Mic/Line 2
Gain/Phantom
Auto Memory Subnet Mask Active Output
Details
Test Pattern Total Pixels/
Phase
Mic/Line
Volume
Overscan Gateway Detected
Displays
DHCP HDCP
Authorization
Program
Volume
Factory Reset
IP Address EDID Output 1/2
Format
NOTE: The Communication submenu is normally locked. Press and hold the Enter
button for 10 seconds to unlock the submenu items.
2. Press the Enter or Right button to open submenu items.
3. Press the Up or Down button to navigate the submenu items.
4. Press the Menu button to exit a submenu item or return to the previous submenu.
To adjust a submenu item:
1. Navigate to an adjustable item and press the Enter or Right button to select the
submenu item.
2. Press the Left or Right button to select a submenu item or a specific adjustable setting
within the selected submenu item.
If the selected submenu item has multiple adjustable settings, press the Up or Down
button to select a value.
3. Press the Enter button to accept the new value.
Press the Menu button to cancel any pending changes.
To exit the OSD menu:
Hold the Menu button for 3 seconds to exit the OSD menu.
