xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
50
DGS–3426:5#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name/SNMPv3 User Name
––––––––––––––– ––––––––––––––– ––––––––––––––––––––––––––
10.48.76.23 V2c private
10.48.74.100 V3 authpriv public
Total Entries: 2
DGS–3426:5#
show snmp v6host
Purpose Used to display the IPv6 recipient of SNMP traps generated by the Switch’s SNMP agent.
Syntax
show snmp v6host {<ipv6addr>}
Description This command is used to display the IPv6 addresses and configuration information of
remote SNMP managers that are designated as recipients of SNMP traps that are
generated by the Switch’s SNMP agent.
Parameters
v6host <ipv6addr> − The IPv6 address of a remote SNMP manager that will receive
SNMP traps generated by the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently configured IPv6 SNMP hosts on the Switch:
DGS–3426:5#show snmp host
Command: show snmp host
SNMP Host Table
–––––––––––––––––––––––––––––––––––––––––––––––––––––––
Host IPv6 Address : FF::FF
SNMP Version : V3 na/np
CommunityName/SNMPv3 User Name : initial
Total Entries: 1
DGS–3426:5#
enable snmp traps
Purpose Used to enable SNMP trap support.
Syntax
enable snmp traps
Description This command is used to enable SNMP trap support on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable SNMP trap support on the Switch:
