A SERVICE OF

logo

Open as PDF
next previous
xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
343
DGS–3426:5#disable loopdetect
Command: disable loopdetect
Success.
DGS–3426:5#
show loopdetect
Purpose Used to display the switch’s current loop-detect configuration.
Syntax
show loopdetect
Description The show loop-detect command displays the switch’s current loop-detect configuration.
Parameters None.
Restrictions None.
Example usage:
To display loop-detect:
DGS–3426:5# show loopdetect
Command: show loopdetect
LBD Global Settings
----------------------------------------
LBD Status : Enabled
LBD Interval : 20
LBD Recover Time : 60
DGS–3426:5#
show loopdetect ports
Purpose Used to display the switch’s current per–port loop-detect configuration.
Syntax
show loopdetect ports [all | <portlist> ]
Description The show loop-detect ports command displays the switch’s current per-port loop-detect
configuration and status.
Parameters portlist – Specifies a range of ports to be displayed. (UnitID:port number).
all – System will display all ports loopdetect information.
Restrictions None.
Example usage:
To display loop-detect state of port 1–8 in port–based mode: