xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
153
DGS–3426:5#config ipif Tiberius ipv6 ipv6address 3ffe:501:ffff:100::1/64
Command: config ipif Tiberius ipv6 ipv6address 3ffe:501:ffff:100::1/64
Success.
DGS–3426:5#
show ipif
Purpose Used to display the configuration of an IP interface on the Switch.
Syntax
show ipif {<ipif_name 12>}
Description This command is used to display the configuration of an IP interface on the Switch.
Parameters
<ipif_name 12> − The name created for the IP interface which will be viewed.
Restrictions None.
Example usage:
To display IP interface settings:
DGS–3426:5#show ipif System
Command: show ipif System
Interface Name : System
VLAN Name : default
Interface Admin State : Enabled
IPv4 Address : 10.48.74.122/8 (MANUAL)
IPv6 Link–Local Address : FE80::217:9AFF:FEBA:72CB/128
Interface Name : Zira
VLAN Name : Tiberius
Interface Admin State : Enabled
IPv4 Address : 0.0.0.0/0 (MANUAL)
IPv6 Link–Local Address : FE80::217:9AFF:FEBA:72CB/128
IPv6 Global Unicast Address : 3FFE:501:FFFF:100::1/64
Total Entries : 2
DGS–3426:5#
enable ipif
Purpose Used to enable an IP interface on the Switch.
Syntax
enable ipif {<ipif_name 12> | all}
Description This command is used to enable the IP interface function on the Switch.
Parameters
<ipif_name 12> − The name of a previously configured IP interface to enable. Enter an
alphanumeric entry of up to twelve characters to define the IP interface.
all – Entering this parameter will enable all the IP interfaces currently configured on the
Switch.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the IPIF function on the Switch:
