xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
328
config jwac ports
Purpose Used to configure the JWAC port state.
Syntax
config jwac ports [<portlist> | all] {state [enable | disable] |
max_authenticating_host <value 0–50> | aging_time [infinite | <min 1–1440>] |
idle_time [infinite | <min 1–1440>] | block_time [<sec 0–300>] | auth_mode
[host_based | port_based] }(1)
Description This command is used to configure the JWAC port state.
The max authenticating host default value is 50.
The default aging time is 1440 minutes.
The default idle time is infinite.
The default block time is 60 seconds.
The default mode is host-based.
Parameters <portlist> – A port range to set the JWAC state.
all – All the Switch ports’ JWAC state is to be configured.
state – To specify the port state of JWAC
max_authenticating_host – Max number of host process authentication on each port at
the same time.
The max authenticating hosts depends on a specific project.
aging_time – A time period during which an authenticated host will keep the
authenticated state.
“infinite” indicates never to age out the authenticated host on the port
idle_time – If there is no traffic during idle_time, the host will be moved back to the
unauthenticated state
“infinite” indicates never to check the idle state of the authenticated host on the port.
block_time – If a host fail to pass the authentication, it will be blocked for a period
specified by block_time.
auth_mode – The port authentication mode can be either host based or port based.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure JWAC ports:
DGS–3426:5#config jwac port 1
–
9 state enable
Command: config jwac port 1
–
9 state enable
Success.
DGS–3426:5#
