xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
138
show lacp_port
Purpose Used to display current LACP port mode settings.
Syntax
show lacp_port {<portlist>}
Description This command is used to display the LACP mode settings as they are currently
configured.
Parameters <portlist> – Specifies a port or range of ports to be displayed. The port list is specified by
listing the lowest switch number and the beginning port number on that switch, separated
by a colon. Then the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3–2:4 specifies all of the ports between switch 1,
port 3 and switch 2, port 4 − in numerical order. Non–contiguous portlist entries are
separated by a comma. (ex: 1:1–1:3,1:7–1:9)
If no parameter is specified, the system will display the current LACP status for all ports.
Restrictions None.
Example usage:
To display LACP port mode settings:
DGS–3426:5#show lacp_port 1:1–1:10
Command: show lacp_port 1:1–1:10
Port Activity
––––
––
––––––––
1:1 Active
1:2 Active
1:3 Active
1:4 Active
1:5 Active
1:6 Active
1:7 Active
1:8 Active
1:9 Active
1:10 Active
DGS–3426:5#
