xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
301
DGS–3426:5#show sim group
Command: show sim group
SIM Group Name : default
ID MAC Address Platform / Hold Firmware Device Name
Capability Time Version
––
–
–––––––––––––– ––––––––––––––– ––––
–
––––––––
–
-------------
*1 00–01–02–03–04–00 DGS–3400 L2 Switch 40 2.00.B46 Trinity
2 00–55–55–00–55–00 DGS–3400 L2 Switch 140 2.00.B46 default master
SIM Group Name : SIM2
ID MAC Address Platform / Hold Firmware Device Name
Capability Time Version
––
–
–––––––––––––– ––––––––––––––– ––––
–
–––––––– ---------------
*1 00–01–02–03–04–00 DGS–3400 L2 Switch 40 2.00.B46 Neo
2 00–55–55–00–55–00 DGS–3400 L2 Switch 140 2.00.B46 default master
‘*’ means commander switch.
DGS–3426:5#
Example usage:
To view SIM neighbors:
DGS–3426:5#show sim neighbor
Command: show sim neighbor
Neighbor Info Table
Port MAC Address Role
–––––– –––––––––––––––––– –––––––––
23 00–35–26–00–11–99 Commander
23 00–35–26–00–11–91 Member
24 00–35–26–00–11–90 Candidate
Total Entries: 3
DGS–3426:5#
reconfig
Purpose Used to connect to a member switch, through the commander switch, using Telnet.
Syntax
reconfig {member_id <value 1–32 | exit}
Description This command is used to reconnect to a member switch using Telnet.
Parameters member_id <value 1–32> – Select the ID number of the member switch to configure.
exit – This command is used to exit from managing the member switch and will return to
managing the commander switch.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To connect to the MS, with member ID 2, through the CS, using the command line interface:
DGS–3426:5#reconfig member_id 2
Command: reconfig member_id 2
DGS–3426:5#
Login:
