xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
247
disable dhcp_relay
Purpose Used to disable the DHCP/BOOTP relay function on the Switch.
Syntax
disable dhcp_relay
Description This command is used to disable the DHCP/BOOTP relay function on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable DHCP relay:
DGS–3426:5#disable dhcp_relay
Command: disable dhcp_relay
Success.
DGS–3426:5#
config dhcp_relay option_60 state
Purpose This command is used to configure the state of DHCP relay agent information option 82
of the switch. Used to configure the DHCP relay opton 60 state.
Syntax
config dhcp_relay option_60 state [enable |disable]
Description This command is used to decide whether the DHCP relay will process the DHCP option
60 or not. When option_60 is enabled, if the packet does not have option 60, then the
relay servers cannot be determined based on option 60. The relay servers will be
determined based on either option 61 or per IPIF configured servers. If the relay servers
are determined based on option 60 or option 61, then per IPIF configured servers will be
ignored. If the relay servers are not determined either by option 60 or option 61, then per
IPIF configured servers will be used to determine the relay servers.
Parameters enable – Enables the fuction.
disable – Disables the fuction.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure DHCP relay option 60 state:
DGS–3426:5#config dhcp_relay option_60 state enable
Command: config dhcp_relay option_60 state enable
Success.
DGS–3426:5#
