xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
186
Command Parameters
create 802.1x guest_vlan <vlan_name 32>
config 802.1x guest_vlan ports
[<portlist> | all] state [enable | disable]
delete 802.1x guest_vlan {<vlan_name 32>}
show 802.1x guest_vlan
config 802.1x auth_failover [enable | disable]
config 802.1x fwd_pdu system [enable | disable]
config 802.1x fwd_pdu ports
[<portlist>|all] [enable | disable]
config 802.1x authorization network
radius
[enable | disable]
config 802.1x max_users [<value 1 – 4000> | no_limit]
config accounting service [network | shell | system] state [enable | disable]
show accounting service
Each command is listed, in detail, in the following sections
enable 802.1x
Purpose Used to enable the 802.1X server on the Switch.
Syntax
enable 802.1x
Description This command is used to enable the 802.1X Network Access control server application
on the Switch. To select between port–based or MAC–based, use the config 802.1x
auth_mode command.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable 802.1X switch wide:
DGS–3426:5#enable 802.1x
Command: enable 802.1x
Success.
DGS–3426:5#
disable 802.1x
Purpose Used to disable the 802.1X server on the Switch.
Syntax
disable 802.1x
Description This command is used to disable the 802.1X Network Access control server application
on the Switch. To select between port–based or MAC–based, use the config 802.1x
auth_mode command.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable 802.1X on the Switch:
