Filter
Top Products
Page 27
Figure 9-2. Gearing and Load Brake Parts. (Cont’d.)
Ref. Part Qty.
No. Number Description Req’d.
15 800-219 Ring — Retaining, Drum Shaft Bearing 1
17 800-221 Ring — Retaining 1
18† 800-222 Bearing Assembly — Roller, Intermediate Shaft 1
19 800-269 Cover — Oil Hole 1
20 800-224 Pipe Plug — Hex Socket 1
21† 800-225 Oil Seal — Motor Shaft 1
22† 800-226 Bearing Assembly — Ball, Motor Shaft 1
23† 800-227 Bearing Assembly — Needle, Load Brake Shaft 1
24 800-228 Ring — Retaining, Motor Shaft Bearing 1
25 800-229 Washer — Thrust (Steel) 1
Brake Assembly — Load, Complete (Includes Items 26 thru 37) 1
800-230 23 Teeth
800-231 36 Teeth
800-267 24 Teeth
800-232 18 Teeth
800-2232A 20 Teeth
26 800-233 Ring — Retaining, Brake Flange 1
27 800-234 Flange — Load Brake 1
28* 800-235 Washer — Friction 2
29 800-236 Pawl & Ratchet Assembly — Load Brake (Available Only As An Assembly) 1
30 800-237 Bushing — Ratchet 1
31 800-238 Gear & Center Assembly 1
32 800-239 Pin — Groove 2
33† 800-240 Cam — Load Brake 1
34† 800-241 Spring — Load Brake 1
35 800-242 Retainer — Spring, Load Brake 1
36 800-243 Key — Woodruff 2
37 Shaft & Integral Pinion — Load Brake 1
800-244 23 Teeth
800-245 36 Teeth
800-268 24 Teeth
800-246 18 Teeth
800-2246A 20 Teeth
38† 800-247 Washer — Thrust (Used With 800-246 Only) 1
39† 800-248 Washer — Thrust (Bronze) 1
40† 800-249 Bearing Assembly — Needle, Load Brake Shaft 1
* 800-250 Load Brake — Clutch Assembly With Bearings (Complete) 1
** 800-251 Load Brake — Clutch Assembly (Includes Items 26 thru 30, 34, 36 thru 38
and 43 thru 45) 1
43 800-254 Spring Retainer
Available only as part of
44 800-253 Brake Gear, Center
}
800-250 or 800-251 above
45 800-252 Clutch Assembly
46 800-260 Ring — Retaining 3
47 800-263 Oil Seal — Drum Shaft 1
48 800-261 Bearing Assembly — Ball, Drum Shaft 1
49 800-262 Shaft — Drum 1
† Recommended spares.
* Recommended Replacement Kit for Load Brake Clutch (Complete).
** Replacement Complete, Less Bearings and Thrust Washers.
For hoists built prior to March, 1997, gearing part numbers, with four digits (rather than three) after “800-”, must be replaced in sets.
For hoists built between March 1, 1997 and July 1, 1997, contact the factory for gearing requirements.