Filter
Top Products
6—Using the S-1608/S-0816 System
48 S-1608/S-0816 Digital Snake Owner’s Manual
fig.6-35.eps
Ordinarily, when plugging and unplugging devices to and from the
audio inputs and outputs on the S-1608 and S-0816 units, the volume
of all devices connected to the S-1608/S-0816 System’s audio outputs
should be lowered.
However, this may be impractical in some circumstances. In such cases,
you can temporarily mute the sound coming from the S-1608/S-0816
System’s audio outputs.
1. On the S-1608 or S-0816 front panel, press and hold the [MUTE ALL OUTPUTS] button. After
approximately 1.5 seconds, its indicator will light. No sound is output while the indicator is lit.
2. When you have finished making input connections to the unit, release [MUTE ALL OUTPUTS].
Muting the System Outputs
The system outputs will become un-muted after releasing [MUTE ALL OUTPUTS]. If audio is passing
through the system when [MUTE ALL OUTPUTS] is released, the sound may be distorted until the
system outputs are completely un-muted.
Note that [MUTE ALL OUTPUTS] only mutes the outputs of the S-4000 System, and not the outputs of
other devices. Before connecting the audio outputs on the S-1608 and S-0816 units to the audio
inputs of other devices, always turn down the volume or turn off the power on the receiving devices.
When an S-4000R is connected to the system, its CHANNEL display flashes when the audio outputs
are muted using [MUTE ALL OUTPUTS].
If the REAC cable is disconnected while [MUTE ALL OUTPUTS] is held, it’s possible that one of the S-
1608/S-0816 units will remain in a muted state when [MUTE ALL OUTPUTS] is released. If this occurs,
use the following procedure:
1. Reconnect the REAC cable.
2. Press and release [MUTE ALL OUTPUTS].
Indicator
S-1608_e.book 48 ページ ２００７年４月２３日 月曜日 午後１２時５７分