Filter
Top Products
4—Panel Descriptions
S-1608/S-0816 Digital Snake Owner’s Manual 19
5—Digital Out Connector (Optical Type)
This optical type digital out connector outputs the audio signal input to INPUT 1/2 of the S-1608/S-
0816.
6—[MUTE ALL OUTPUTS] Button
The [MUTE ALL OUTPUTS] button is a momentary switch used to temporarily mute the S-1608/
S-0816 System’s audio outputs. This allows for noise-free connection of audio input sources.
Press and hold the [MUTE ALL OUTPUTS] button. After approximately 1.5 seconds, its
indicator lights. While the indicator is lit, the audio outputs of all connected REAC
devices are muted.
7—[REAC MODE] Switch
This switch sets the S-1608’s or S-0816’s REAC device behavior.
•
M
—configures the S-1608/S-0816 as a Master REAC device.
•
S
—configures the S-1608/S-0816 as a Slave REAC device.
•
SP
—configures the S-1608/S-0816 as a Split REAC device.
8—REAC Indicator
This indicator lights when REAC communication is established within the S-1608/S-0816 System. If
REAC communication fails, this indicator will flash and then go out.
9—Power Indicator
This indicator lights when the S-1608/S-0816 is receiving power from its internal power supply.
The system outputs will become un-muted after [MUTE ALL OUTPUTS] is released. If audio is passing
through the system when [MUTE ALL OUTPUTS] is released, the sound may be distorted until the
system outputs are completely un-muted.
If the exhaust fan has stopped working for any reason, the [MUTE ALL OUTPUTS] indicator will flash.
See:
Appendix A: Troubleshooting
.
The [REAC MODE] switches must be set properly for the system to work. See Chapters 6 and 7 for
information on configuring the system and setting the [REAC MODE] switches.
Indicator
S-1608_e.book 19 ページ ２００７年４月２３日 月曜日 午後１２時５７分