Filter
Top Products
S-1608/S-0816 Digital Snake Owner’s Manual 3
THE UNIT SAFELY
001
●
Before using this unit, make sure to read the
instructions below, and the Owner’s Manual.
.....................................................................................................
001-50
●
Connect mains plug of this model to a mains socket
outlet with a protective earthing connection.
.....................................................................................................
002a
●
Do not open or perform any internal modifications on
the unit.
.....................................................................................................
003
●
Do not attempt to repair the unit, or replace parts
within it (except when this manual provides specific
instructions directing you to do so). Refer all servicing
to your retailer, the nearest Roland Service Center, or
an authorized Roland distributor, as listed on the
“Information” page.
.....................................................................................................
004
●
Never use or store the unit in places that are:
• Subject to temperature extremes (e.g., direct
sunlight in an enclosed vehicle, near a heating duct,
on top of heat-generating equipment); or are
• Damp (e.g., baths, washrooms, on wet floors); or
are
• Humid; or are
• Exposed to rain; or are
• Dusty; or are
• Subject to high levels of vibration.
.....................................................................................................
005
●
This unit should be used only with a rack or stand that
is recommended by Roland.
....................................................................................................
006
●
When using the unit with a rack or stand
recommended by Roland, the rack or stand must be
carefully placed so it is level and sure to remain stable.
If not using a rack or stand, you still need to make sure
that any location you choose for placing the unit
provides a level surface that will properly support the
unit, and keep it from wobbling.
....................................................................................................
008a
●
The unit should be connected to a power supply only
of the type described in the operating instructions, or
as marked on the rear side of unit.
....................................................................................................
008e
●
Use only the attached power-supply cord. Also, the
supplied power cord must not be used with any other
device.
....................................................................................................
009
●
Do not excessively twist or bend the power cord, nor
place heavy objects on it. Doing so can damage the
cord, producing severed elements and short circuits.
Damaged cords are fire and shock hazards!
....................................................................................................
011
●
Do not allow any objects (e.g., flammable material,
coins, pins); or liquids of any kind (water, soft drinks,
etc.) to penetrate the unit.
....................................................................................................
Used for instructions intended to alert the
user to the risk of injury or material damage
should the unit be used improperly.
* Material damage refers to damage or
other adverse effects caused with respect
to the home and all its furnishings, as well
to domestic animals or pets.
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
The ● symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
plug must be unplugged from the outlet.
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is
determined by the design contained within the triangle.
In the case of the symbol at left, it is used for general
cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never
be carried out (are forbidden). The specific thing that
must not be done is indicated by the design contained
within the circle. In the case of the symbol at left, it
means that the unit must never be disassembled.
The Name Plate is attached to the rear panel. Please see “Specifications” (Page 72 and Page 73) for information regarding electronic specifications.
S-1608_e.book 3ページ ２００７年４月２３日 月曜日 午後１２時５７分