Filter
Top Products
SECTION 12—ACCESSORIES
Lynx™L-3 & Lynx L-4 48 Part No. 1143205
Installing/Removing the Walker Holder
NOTE: For this procedure, refer to FIGURE 12.4.
NOTE: Reverse this procedure to remove the walker holder.
1. If necessary, loosen but DO NOT remove the mounting knob.
2. Install the walker holder into the accessory tube.
3. Thread the mounting knob into the welded nut on the accessory tube. Securely
tighten.
FIGURE 12.4 Installing/Removing the Walker Holder
Using the Walker Holder
NOTE: For this procedure, refer to FIGURE 12.5.
1. Fold walker. Refer to walker instructions.
NOTE: Walker MUST be folded before using walker holder.
2. Hang folded walker on walker holder hooks.
3. Secure walker with hook and loop straps.
FIGURE 12.5 Using the Walker Holder
Walker Holder
Accessory Tubes
Mounting Knob
Hook
Hook and
Loop Strap
Accessory Tubes
Mounting Knob