Filter
Top Products
SECTION 7—SEAT AND ARMS
Lynx™L-3 & Lynx L-4 30 Part No. 1143205
SECTION 7—SEAT AND ARMS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
NOTE: Refer to Label Locations on page 10 for pinch point location.
Removing/Installing the Seat
ƽ WARNING
Before use, ensure that the seat is in the locked position. The seat lever MUST be
pulled up to the 90° position to allow the seat to drop into the locked position. Oth-
erwise, a fall from the scooter could occur causing bodily injury and/or damage to
the scooter.
NOTE: For this procedure, refer to FIGURE 7.1.
Removing
1. Fold down seat back.
2. Pull up the seat lock lever.
3. Lift the seat assembly up and away from the seat post.
Installing
1. Lower the seat assembly onto the seat post.
2. Pull the seat lock lever up to allow the seat to drop into the locked position.
3. Lift up on seat assembly to ensure the seat is secure.
FIGURE 7.1 Removing/Installing the Seat
Seat Lock
Lever
Seat
Assembly