Filter
Top Products
SECTION 12—ACCESSORIES
Part No. 1143205 47 Lynx™L-3 & Lynx L-4
Installing/Removing the Safety Flag
ƽ WARNING
The installation of the safety flag onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.3.
Installing
1. Install the bracket into the accessory tube located on the back of the seat.
2. Install mounting knob to secure the bracket in place. Securely tighten.
3. Install safety flag into bracket.
Removing
1. Remove the safety flag from the bracket.
2. Remove the mounting knob that secures the bracket in place.
3. Remove the bracket from the accessory tube located on the back of the seat.
FIGURE 12.3 Installing/Removing the Safety Flag
Installing/Removing/Using the Walker Holder
ƽ INSTALLATION WARNINGS
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
Bracket
Safety Flag
Accessory Tubes
Mounting Knob