Filter
Top Products
SECTION 9—WHEELS AND CASTERS
Lynx™L-3 & Lynx L-4 36 Part No. 1143205
FIGURE 9.1 Removing/Installing the Drive Wheels
Removing/Installing the Front Wheel
NOTE: For this procedure, refer to FIGURE 9.2.
NOTE: This procedure applies to the Lynx L-3 only.
NOTE: Take note of position and orientation of wheel and mounting hardware before removing.
Removing
1. Turn power off and remove the key from the ignition.
2. Place the front of the powered scooter up on blocks so that the front wheel is off the
ground.
3. Remove the mounting screw, locknut, two spacers and washer that secure the front
wheel to the fork.
4. Remove the front wheel from the fork.
Installing
1. Align the front wheel with the fork
mounting holes.
2. Using the mounting screw, locknut,
two spacers and washer, secure the
front wheel to the fork.
3. Securely tighten the front wheel
mounting hardware.
FIGURE 9.2 Removing/Installing the Front
Wheel
Keystock
Drive Shaft
Washer
Drive Wheel
Mounting
Screw
NOTE: Front wheel shown.
Rear wheel installs the same
way.
Fork
Mounting
Hole
Spacer
Locknut
Fork
Mounting
Screw
Spacer
Front
Wheel
Fork
Mounting
Hole
Washer