Filter
Top Products
SECTION 10—BATTERIES
Part No. 1143205 39 Lynx™L-3 & Lynx L-4
FIGURE 10.2 Removing/Installing the Battery Box
Removing/Installing the Batteries
NOTE: For this procedure, refer to FIGURE 10.3.
Removing
1. Remove the seat. Refer to Removing/Installing the Seat on page 30.
2. Remove the battery box from the scooter. Refer to Removing/Installing the Battery Box
on page 38.
3. Remove the twelve mounting screws (not shown) that secure the battery box top to the
battery box (Detail “A” of FIGURE 10.3).
NOTE: Mounting screws are located on the underside of the battery box.
4. Disconnect the wiring harness from the batteries by holding the connectors and
pulling them in the following order (Detail “B” of FIGURE 10.3):
A. NEGATIVE (-) BLACK battery cable from the NEGATIVE (-) battery terminal on
the left battery.
B. POSITIVE (+) RED battery cable from the POSITIVE (+) battery terminal on the
right battery.
C. WHITE battery cable (Jumper) from the POSITIVE (+) battery terminal on the left
battery and the NEGATIVE (-) battery terminal on the right battery.
5. Remove the tape securing the thermal switch to the side of the left battery.
6. Remove the batteries from battery box by lifting the batteries out.
Battery Box
Battery Box Handle
Battery Tray
Connector on Base
DETAIL “A” DETAIL “B”