Filter
Top Products
SECTION 10—BATTERIES
Lynx™L-3 & Lynx L-4 42 Part No. 1143205
7. Plug the other end of the battery charger cable into 110-volt wall outlet.
NOTE: The battery charger light will be YELLOW or RED.
8. Allow the batteries to charge until the charger light turns GREEN.
9. Perform one of the following:
• Battery charger light turns GREEN - Unplug the battery charger cable from the
scooter and the wall outlet.
• Battery charger light flashes GREEN for over 40 minutes - Perform the following
steps:
i. Check that the battery charger is correctly connected to the scooter and the wall
outlet.
ii. Check that the scooter is turned off.
iii. If steps i and ii do not correct the problem, contact a qualified technician.
10. Unplug the battery charger from the wall outlet.
11. Unplug the battery charger from the scooter.
12. Store the battery charger cable in the storage compartment.
13. Move the battery charger port cap to cover the battery charger port.
14. If removed, install the battery box onto the scooter. Refer to Removing/Installing the
Battery Box on page 38.
FIGURE 10.4 Charging the Batteries
Battery Charger Port Cap
Battery Charger
Port
Wall Outlet
Battery Charger Indicator Light
Battery Box
Battery Charger
Cable
Storage Compartment