Filter
Top Products
SECTION 10—BATTERIES
Part No. 1143205 41 Lynx™L-3 & Lynx L-4
Charging the Batteries
ƽ WARNING
NEVER attempt to recharge the batteries by attaching cables directly to the
battery terminals or clamps.
DO NOT attempt to recharge the batteries and operate the powered scooter at
the same time.
Only use the provided charger with this product.
CAUTION
New batteries MUST be fully charged prior to initial use of the powered scooter.
DO NOT sit in the scooter while recharging the batteries.
ALWAYS charge new batteries before initial use or battery life will be reduced.
As a general rule, you should recharge your batteries as frequently as possible to
assure the longest possible life and to minimize required charging time. Plan to
recharge them when you do not anticipate using the powered scooter.
The range per battery charge using recommended batteries should be approximately five
to nine hours of typical operation. Extensive use on inclines may substantially reduce per
charge mileage.
ƽ WARNING
If the circuit breaker trips repeatedly, IMMEDIATELY unplug charger and contact
dealer or a qualified technician.
NOTE: For this procedure, refer to FIGURE 10.4.
NOTE: The powered scooter is designed with an electrical lockout to prevent it from being driven
while the charger is plugged into an outlet.
NOTE: Always charge the batteries completely until the battery charger light turns GREEN.
1. Turn the key to the Off position.
2. If desired, remove the battery box from the scooter. Refer to Removing/Installing the
Battery Box on page 38.
3. Ensure the brake release lever is engaged. Refer to Engaging/Disengaging the Brake
Release Lever on page 29.
4. Move the battery charger port cap (located on the left side of the battery box) to one
side.
5. Remove the battery charger cable from the storage compartment on the front of the
battery box.
6. Plug one end of the battery charger cable into the battery charger port located on the
battery box.