Filter
Top Products
SECTION 9—WHEELS AND CASTERS
Part No. 1143205 35 Lynx™L-3 & Lynx L-4
SECTION 9—WHEELS AND CASTERS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power Off and
remove key from ignition.
Removing/Installing the Drive Wheels
NOTE: For this procedure, refer to FIGURE 9.1 on page 36.
NOTE: This procedure applies to the rear wheels on the Lynx L-3 and all wheels on the Lynx L-4.
Removing
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Seat on page 30.
3. Place the rear frame assembly (not shown) up on blocks so that the drive wheels are
off the ground.
4. Remove the washer and mounting screw that secure the drive wheel to the drive shaft.
5. Remove the existing drive wheel assembly from the drive shaft.
NOTE: Use a wheel puller if necessary to remove the wheel from the drive shaft.
6. Remove keystock from drive shaft. Set aside.
7. If necessary, repeat STEPS 1-7 to remove other drive wheel.
Installing
1. Place keystock in cutout on drive shaft as shown in FIGURE 9.1.
NOTE: The keystock in the drive shaft MUST lineup with the cutout in the wheel hub.
NOTE: If necessary, use a rubber hammer to gently tap drive wheel completely into position on the
drive shaft.
2. Install the drive wheel onto the drive shaft.
3. Secure wheel to drive shaft using the mounting screw and washer. Securely tighten.
4. Repeat STEPS 1-3 to install the other drive wheel.
5. Install the seat. Refer to Removing/Installing the Seat
on page 30.