Filter
Top Products
SECTION 4—SAFETY INSPECTION
Lynx™L-3 & Lynx L-4 20 Part No. 1143205
❑ Tighten locknut if the front wheel wobbles noticeably or loosen locknut if the wheel
binds to a stop.
❑ Ensure that wheel bearings are clean and free of moisture.
❑ Ensure that the bolts and fasteners on the caster assemblies are tight.
❑ Inspect tires for flat spots and wear.
❑ Clean molded body shrouds.
❑ Check that all labels are present and legible.
Inspect/Adjust Weekly
❑ Ensure that tiller adjustment mechanism engages and disengages properly and
securely.
❑ Ensure that the scooter stops completely when throttle is released (i.e., does not
continue to roll as if the throttle is activated).
❑ Inspect tires for flat spots and wear.
Inspect/Adjust Monthly
❑ Check brake for binding or interference with travel.
❑ Inspect front wheel/fork assembly for proper tension by spinning the wheel. The front
wheel should come to a gradual stop.
❑ Tighten locknut if the front wheel wobbles noticeably or loosen locknut if the wheel
binds to a stop.
❑ Inspect seat swivel for release and engagement (seat locks into the determined swivel
positions).
❑ Inspect the seat positioning strap for signs of wear. Replace if worn or damaged.
❑ Inspect seat positioning strap for any signs of wear. Ensure buckle latches. Verify that
the hardware that attaches the seat positioning strap to the frame is secure and
undamaged. Replace if necessary.
❑ Ensure that the bolts and fasteners on the caster assemblies are tight.