Filter
Top Products
SECTION 2—ASSEMBLY
Part No 1150704 11 Jasmine™ Patient Lift
Attaching the Battery Charger Mounting Bracket to the Wall
NOTE:Forthisprocedure,refertoFIGURE 2.2.
1. Placethebatterychargermountingbracketonthewallatthedesiredposition.
2. Withapencil,markthemiddleholeposition.
3. Measuredown6½inchesfromthepencilmarkanddrillonemountinghole.
4. Installthebottommountingscrewuntilthereisa1/8‐inchgap
betweenthescrewheadandthewall.
5. Putthebatterychargermountingbracketontothebottommountingscrew.
6. Drilltheothertwomountingholes.
7. Screwthemountingscrewsthroughthebatterycharger
mountingbracketandintothewall.Tightensecurely.
CAUTION
Make sure there is an audible click when mount-
ing battery on the battery charger to confirm
proper mounting. Otherwise, injury or damage
may occur.
8. Putthebatterychargerinplaceonthemountingbracket.
9. Plugthebatterychargerintoanelectr icaloutlet.
NOTE:AnLEDwillilluminatewhen poweris appliedtobattery
charger.
Attaching the Battery Charger to the
Mast Assembly
ƽ WARNING
If the battery charger is attached to the mast
assembly and is plugged into a wall outlet, make
sure to unplug the battery charger from the wall
outlet BEFORE using the patient lift. Failure to
unplug the battery charger may result in injury
or damage.
NOTE:Forthisprocedure,refertoFIGURE 2.3.
1. Locktherearcasterstose curetheliftinplacewhile
performingthisprocedure.
2. Removethetwomylarpiecescoveringthebatterych arger
mountingholesonthebackofthemastassembly.
3. Insertthehookscrewsintomountingholes.
4. Tightenthehookscrews.
5. Mountthebattery
chargermountingbracketonthehook
screws.
6. Chargethebattery. RefertoChargingtheBattery
on
page 13.
FIGURE 2.2 Attaching the Battery Charger Mounting
Bracket to the Wall
FIGURE 2.3 Attaching the Battery Charger to the Mast
Assembly
Mounting Bracket
Mounting Screws
Bottom Mounting Screw
Battery and Battery Charger
shown in place