Filter
Top Products
HE/001132 Page 63 of 92
Document No.001132, Revision 2.0
NodeID Livelink : 14140190
Agfa HealthCare 14 June, 2007
With RIS mapping, the incoming SPS attributes of the RIS are mapped to the internal data structure of
"Workstation". Standard the system will provide a default (1:1) mapping. However in cases where the RIS
sends out the RIS data in a non DICOM conformant way, the customization of the mapping needs to be done
by the operator. This can be done in the "Workstation Service & Configuration Tool".
2.4.1.2.3 MPPS
MPPS reporting can be enabled/ disabled by the operator.
The "Workstation Service & Configuration Tool" must be used to set the AE Title, port-number, host-name
and capabilities of the remote MPPS SCP. Only one single remote MPPS SCP can be defined at a time.
2.4.1.2.4 Printing
The "Workstation Service & Configuration Tool" must be used to set the AE Titles, port-numbers, host-
names and capabilities for the printers. Only the supported printers can be configured. Multiple printers can
be defined.
The DICOM attributes per printer that are configurable are defined in Table 2.2-24, Table 2.2-27, Table
2.2-29
Additionally, the following parameters can be configured
Table 2.4-4: Configurable Printer parameters.
Parameter Configurable
(yes/no)
Name
Yes
Description
Yes
Use N-Events
Yes
IP Address
Yes
Port Number
Yes
AE Title
Yes
SSL Enabled
Yes
2.4.1.3 Queue Management & Job description
2.4.1.4 DICOM Store AE
2.4.1.4.1 Queue description
Each Remote Store AE destination has its own configuration (as described in §2.4.1.2.1) and queue. For
each destination, a different retry policy can be configured.
It is possible to configure the rerouting of a DICOM Store queue. A typical example for when this is needed is
a PACS that is temporarily down. The queue can be rerouted to a web server. This web server will then later