Filter
Top Products
11
5. Weighing Units
5.1. Units
All weighing units and weighing modes are as follows:
A unit or mode can be selected and stored in the function table as described in "5.2.
Changing the Units".
If the law in your area permits, you may use all of the units. You can disable the units that
you don't regularly use. And you are able to turn them back on.
If a weighing mode (or unit of mass) has been turned off, that mode or unit will be
missing in the sequence. Tael has four varieties, one of which can be selected and
installed at the factory.
To select a unit or mode for weighing, press the MODE key.
For details about the units and modes, see the table below:
Name (unit, mode) Abbreviation Display unit
Conversion
factor
Gram g
1 g
Milligram mg
0.001 g
Counting mode pcs
-
Percent mode %
-
Ounce (Avoir) oz
28.349523125 g
Troy Ounce ozt
31.1034768 g
Metric Carat ct
0.2 g
Momme mom
3.75 g
Pennyweight dwt
1.55517384 g
Grain (UK) GN
0.06479891 g
Tael (HK general, Singapore)
37.7994 g
Tael (HK jewelry)
37.429 g
Tael (Taiwan)
37.5 g
Tael (China)
tl
31.25 g
Tola (India) t
11.6638038 g
Messghal m
4.6875 g
Density mode d Refer to
"14. Density Measurement"
g mg pcs % oz ozt ct
d m t tl GN dwt mom
Density mode
To use this mode, it must be stored in the function table as described on page
14. For details about this mode, refer to "14. Density Measurement".
To select this mode, press the MODE key until the processing indictor
blinks with the unit "g" displayed.
Percent mode
Counting mode