6 Getting Started
RX2 Reference Guide E-EQ-RX2RG-B
Quick Configuration
1. Establish a USB ActiveSync connection and start ActiveSync Remote Display. See section
below or refer to “ActiveSync and the RX2” in Chapter 3, System Configuration for more
details.
2. Configure the RX2 Software Update Manager, if desired. See “Software Update Manager” in
Chapter 3, “System Configuration” for more details.
3. Make any desired changes in the Windows CE .NET Control Panel. Please refer to Chapter 3,
“System Configuration” for more information.
4. Configure the 802.11 radio. At a minimum the following items are required:
• Network SSID or ESSID number of the Access Point
• WEP or WPA Authentication Protocol Keys as necessary
Also see Chapter 5, “Wireless Network Configuration” for information on configuring the
802.11 radio.
ActiveSync – Initial Setup
The following instructions relate to initial setup of ActiveSync.
USB Connection
By default, the RX2 is configured for a USB connection. Once the RX2 has finished booting,
connect the ActiveSync cable to the RX2 and the PC.
** Cable for initial ActiveSync Configuration:
USB Client to PC/Laptop USB-Client cable MX3XA069CBLD9USBCLNT
ActiveSync starts automatically and establishes the connection between the RX2 and the PC.
The ActiveSync connection can be used to configure the RX2 using ActiveSync Remote Display
or to synchronize data between the RX2 and PC.
Configuration
It is necessary to use the ActiveSync connection and ActiveSync Remote Display to configure the
RX2.
Please refer to Chapter 3, “System Configuration” for information on ActiveSync Remote Display
and configuration options for the RX2.
Please refer to Chapter 5, “Wireless Network Configuration” for information on configuring the
RX2’s 802.11 radio.
Disconnect
Disconnect the cable from either the mobile device or the PC to end the ActiveSync session.
