A SERVICE OF

logo

Cisco Radio 119
E-EQ-RX2RG-B RX2 Reference Guide
Wireless Network Configuration for PSK
Use the following instructions for all authentication protocols to configure the Microsoft Wireless
Network configuration utility unless WPA/LEAP is used.
WPA/LEAP is configured with the Cisco ACU (see Section titled “WPA/LEAP Authentication
Configuration”).
Click the ACU icon on the desktop.
Figure 5-23 Cisco ACU Profile Selection
From the “Select Active Profile” pull down list, select <External Settings>.
Click OK and warmboot since the radio card cannot be removed from the RX2
Figure 5-24 Cisco ACU Reboot Message
After booting up, the Microsoft Zero Config tool should start. If it does not, start configuring the
wireless connection by clicking on the icon on the task bar shown in below.
Figure 5-25 Microsoft Wireless Connection Icon