Configuring PAD/ATPAD Ports 61
ATPAD Ports
Configuration
Guidelines
Use these guidelines when you enter ATPAD commands:
• Type the commands in upper, lower, or mixed case. If echo is enabled, the
commands are echoed in all capitals.
• Use white space (TAB and SPACE) characters anywhere on the command
line. The command processor ignores them.
• Edit the buffer using the configurable Back Space Character.
• Be sure that you do not exceed the buffer's maximum length. Otherwise, you
get the result code
ERROR
.
•Type
AT<CR>
to clear the command buffer.
• Be aware that you can:
– Enter commands that are not supported by the ATPAD. You get the result
code OK, but the ATPAD does not act on the unsupported commands.
– Enter multiple commands on a single command line. However, the
ATPAD recognizes only the first supported command.
Configuring The
ATPAD
You can configure the ATPAD port using the CTP by selecting the Port item under
the Configure menu. You can perform these standard Port Control functions using
the CTP:
• Port Boot
• Port Enable
• Port Disable
• Port Busy-out
